This section talks about using LCDproc with LCD displays that use the CFontzPacket chipset. Model= 631 633 635 Select the LCD model [default: 633; legal: 631, 633, 635] Device= DEVICE Select the output device to use [default: /dev/lcd] May be a serial device or a USB device in serial emulation mode. Size= WIDTH x HEIGHT Select the LCD size [default: depending on model: 635: 20x4, 631: 20x2, 633: 16x2] Contrast= CONTRAST Set the initial contrast. Legal values for CONTRAST are 0 - 1000. If not specified, it defaults to 560. Brightness= BRIGHTNESS Set the initial brightness [default: 1000; legal: 0 - 1000] OffBrightness= BRIGHTNESS Set the initial off-brightness [default: 0; legal: 0 - 1000] This value is used when the display is normally switched off in case LCDd is inactive Speed= 1200 2400 9600 19200 115200 Set the the baud rate for communication with the LCD. If not specified, the default depends on the model: it is 9600 for the CFA633 and 115200 for the CFA631 and CFA635. NewFirmware= yes no Set the firmware version (New means >= 2.0) [default: no; legal: yes, no] Currently this flag is not in use, there is no such thing as NewFirmware. ;=) Reboot= yes no Reinitialize the LCD's BIOS [default: no; legal: yes, no] I want to reboot the LCD to make sure we start from a known state