This section talks about using LCDproc with LCD displays that use the CFontz chipset. Device= DEVICE Select the serial output device to use. If not given, default is /dev/lcd. Size= WIDTH x HEIGHT Set the LCD's dimensions in terms of characters per line and lines. If not given, it defaults to 20x4. Contrast= CONTRAST Set the initial contrast. Legal values for CONTRAST are in the range between 0 and 1000. If not given, it defaults to 140. Brightness= BRIGHTNESS Set the initial brightness. Legal values for BRIGHTNESS range from 0 to 1000. If not given, it defaults to 1000. OffBrightness= BRIGHTNESS Set the initial off-brightness. This value is used when the display is normally switched off in case LCDd is inactive. Legal values BRIGHTNESS are in the range from 0 to 1000. The default is 0. Speed= 1200 2400 9600 19200 115200 Set the the baud rate to use when communicating with the LCD. It defaults to 9600 if not specified. NewFirmware= yes no Set the firmware version (New means >= 2.0) [default: no; legal: yes, no] Reboot= yes no Reinitialize the LCD's BIOS [default: no; legal: yes, no] normally you shouldn't need this